Home → Calculator
Christmas light calculator
Pick what you are lighting, type in your measurements, and read off the number of strings. Nothing is sent anywhere — the arithmetic happens in your browser.
Enter your measurements
Six measurements, six answers. Pick what you are lighting, type what you measured, and the number of strings appears below.
The lights you plan to buy
Sets the typical wattage and string length below. Both stay editable.
Printed on the box.
Lit length, not including the lead wire.
We fill in a typical figure. Use the one on your box if it differs.
Add the cost of running them
Replace this with the rate on your own bill — it varies a lot by state.
Add up every gutter, eave and peak you want lit.
Covers corners, drops and the run back to the outlet.
The lights you plan to buy
Sets the typical wattage and string length below. Both stay editable.
Printed on the box.
Lit length, not including the lead wire.
We fill in a typical figure. Use the one on your box if it differs.
Add the cost of running them
Replace this with the rate on your own bill — it varies a lot by state.
A tape measure round the trunk or post.
3 in is dense, 6 in is open.
The lights you plan to buy
Sets the typical wattage and string length below. Both stay editable.
Printed on the box.
Lit length, not including the lead wire.
We fill in a typical figure. Use the one on your box if it differs.
Add the cost of running them
Replace this with the rate on your own bill — it varies a lot by state.
Only used for a spiral.
Only used for a spiral.
The lights you plan to buy
Sets the typical wattage and string length below. Both stay editable.
Printed on the box.
Lit length, not including the lead wire.
We fill in a typical figure. Use the one on your box if it differs.
Add the cost of running them
Replace this with the rate on your own bill — it varies a lot by state.
The lights you plan to buy
Sets the typical wattage and string length below. Both stay editable.
Printed on the box.
Lit length, not including the lead wire.
We fill in a typical figure. Use the one on your box if it differs.
Add the cost of running them
Replace this with the rate on your own bill — it varies a lot by state.
The lights you plan to buy
Sets the typical wattage and string length below. Both stay editable.
Printed on the box.
Lit length, not including the lead wire.
We fill in a typical figure. Use the one on your box if it differs.
Add the cost of running them
Replace this with the rate on your own bill — it varies a lot by state.
What each tab assumes
| Tab | The sum behind it |
|---|---|
| Tree | Bulbs per vertical foot × height. 100 mini or 50 C7 per foot at the classic setting; halved for a slim tree, doubled for a showpiece. |
| Roofline | Your measured run plus a slack percentage for corners, drops and the run back to the outlet. |
| Trunks & columns | (height ÷ gap between turns) × distance around. Pure geometry, no rule of thumb. |
| Railings | Straight: length plus 5%. Spiral: the same geometry as a column, turned on its side. |
| Shrubs | Bulbs per vertical foot × height × a spread factor you choose, because a broad shrub takes more than a narrow one of the same height. |
| Windows | 2 × (width + height) per window, plus 5% slack. |